May 2005 Creative Express Projects
Measurements:
Main card: 9 1/4 x 12
Folds to & finished after cutting (approximately): 6 x 9
CEX173 Shirt and Tie Card
Stamps by: Tie by Parked on Rubber; Sayings by Stampendous! and Hero Arts. Shirt folding pattern by Design Originals.
Supplies needed:
Double stick tape or glue
Pop Dots: 1/16 inch
Dries Clear Adhesive
Instructions
1. Tape (or glue) the shirt onto the main card.
3. Trim around the shirt so that the whole card is
"shirt-shaped". Be sure to save the pieces for the
handkerchief.
4. Place the velvet tie and the pocket onto support cardstock and
detail trim (the tie may already be done).
5. Attach the tie to the main card with pop dots.
6. Complete the inside of the card.
7. Using the dries clear adhesive, glue the pocket to the shirt so
that the pocket "gops" just a little open.
8. Using the dries clear adhesive, glue the rhinestones to the
collar (this step may also already be done).
9. Attach the "U.R. Kule & Co." label to the main
card.
10. Fold a scrap of the white cardstock to resemble a handkerchief
and position inside of the pocket.
CEX174 Gingerbread Man in Stocking Card 2005
Stamps by: Stocking and Gingerbread Man by Heartlooms, Candy Cane by Posh Impressions; Sayings by Penny Black and Hero Arts.
Supplies needed:
Double stick tape or glue
Dries clear adhesive
Pop Dots: 1/16 and 1/8 inch
Measurements:
Main card: 8 1/2 x 11
Folds to: 5 1/2 x 8 1/2
White Panel: 5 1/4 x 8 1/4
Decorative Panel: 5 x 8
Instructions:
1. Place gingerbread man and stocking parts onto
support cardstock and detail trim. ***Place the white cuff onto the
white support stock and then back onto the piece of PNS included in your
package. Detail trim the three layers.***
2. Layer on the white panel (not shown above) and the decorative
gingham.
3. Complete the inside of the card.
4. Place the cuff part of the stocking over the red cuff part of the
stocking.
5. Using the 1/8 pop dots, position the stocking onto the main
card. In placing your pop dots, remember that both the candy cane
and the gingerbread man are going to go down behind the stocking.
6. Position the candy cane onto the main card. (On this
sample, the candy cane is flat on the card).
7. Using the 1/16 inch pop dots, position the gingerbread man onto
the main card. All of his one leg needs to be cut-off (I know, I
know, it is hard to do) so that he fits appropriately.
8. Using the dries clear adhesive, glue the "candy
rhinestones" onto the gingerbread man and allow to dry.
CEX175 Fourth of July House
Stamps by: House by Heartlooms; Sayings by Darcies and Embossing Arts.
Supplies needed:
Double stick tape or glue
Dries clear adhesive
Pop Dots: 1/8 inch
Measurements:
Main card: 9 1/4 x 16
Folds to: 8 x 9 1/4
Red Panel: 7 3/4 x 9
White Panel: 7 5/8 x 8 7/8
Navy Panel: 7 1/2 x 8 3/4
Instructions:
1. Place house and roof images onto support stock
and detail trim.
2. Layer on the colored panels.
3. Complete the inside of the card.
4. Using pop dots, position the house onto the main card.
5. Using the dries clear adhesive, glue the roof piece to the house.
6. Using the dries clear adhesive, glue on all the buttons and allow
to dry.
CEX176 Potted Star Flowers Bright
Stamps by: Star Flowers by Heartlooms; Pot by Darcies; Sayings by Touche, Darcies, Stampa Rosa.
Supplies needed:
Double stick tape or glue
Dries clear adhesive
Pop Dots: 1/16, 1/8, 1/4 inch
Measurements:
Main card: 10 x 14
Folds to: 7 x 10
Purple Panel: 6 3/4 x 9 3/4
Magenta Panel: 6 1/4 x 9 1/4
Flower Panel: 6 x 9
Instructions:
1. Place all images onto the support stock and
detail trim.
2. Layer the cardstock and decorative panels onto the main card.
3. Complete the inside of the card.
4. Using the 1/16 inch pop dots, position the pot onto the main
card.
5. Arrange the flowers onto the main card for placement
purposes. When you are satisfied with your arrangement, use the
variety of pop dots to attach them to the main card. ***Remember
that pop dots will not stick to PNS. When you get to the small
flowers, it is easier to place the pop dots onto the main card and then
place the image onto the pop dot.***
6. Using dries clear adhesive, glue on the rhinestones and allow to
dry.
Measurements:
Main card: 8 1/2 x 11
Folds to: 5 1/2 x 8 1/2
Magenta panel: 5 1/4 x 8 1/4
White panel: 4 3/4 x 7 3/4
Magenta and Vellum panel: 4 1/4 x 7 1/4
CEX177 Wedding Bells Magenta 2005
Stamps by: Bells by Heartlooms; Sayings by Darcies, The Cottage Stamper, Stampendous!
Supplies needed:
Double stick tape or glue
Dries clear adhesive
Pop Dots: 1/8 inch
Two clothes pins
Instructions:
1. Place bells onto support cardstock and detail
trim.
2. Hold together the vellum and matching (size) magenta panel.
See where the bells are going to be positioned and apply double stick tape
to the vellum. Tape the vellum to the magenta panel.
3. Using the pop dots, attach the bells to the vellum/magenta
panel.
4. Using the dries clear adhesive, glue the bows onto the
panel. Use the clothes pins to hold the ribbons in place until they
dry. You can also glue on the rhinestones at this point as well.
5. Tape the larger magenta panel onto the main card.
6. Complete the inside of the card.
7. When the bows are firmly attached, place a bit of double stick
tape to the back of the vellum behind each bow for added support.
8. If you did not glue on the rhinestones earlier, do so now.